Delta LA200 Instruction Manual download pdf (Page 11)

Fig. 19

Fig. 20

For most applications, position the tool rest as close as possible to the workpiece and approximately 1/8” above the workpiece

centerline.

1. To position the tool rest base (A) Fig. 21 along the lathe bed, loosen the locking lever (B), slide the tool rest base to the

desired position, and tighten the lever (B).

2. To adjust the height of the tool rest (C) Fig. 21, loosen the lever (D), raise or lower tool rest, and tighten the lever (D).

3. You can adjust the clamping device on the tool rest base by adjusting the nut (E) clockwise to tighten or counter-clockwise

to loosen the clamping action.

ADJUSTING THE TOOL REST

Disconnect the machine from the power source

Fig. 21 Fig. 22

1. To slide the tailstock along the lathe bed, loosen the locking

lever (A) Fig. 23. Slide the tailstock (B) into position, and

tighten the lever (A). The clamping device for the tailstock

was set prior to shipping. However, if the clamping action

needs adjustment, remove the tailstock and tighten (or

loosen) the nut (C) Fig. 24 on the bottom of the tailstock.

Re-attach the tailstock to the lathe bed.

2. To move the ram (D) Fig. 25, in or out, loosen the locking

lever (E) and turn the handwheel (F). Tighten the lever (E)

after adjusting the ram (D).

NOTE: Total ram (D) travel ranges from 0" to 1-1/2".

Fig. 23

Fig. 24

ADJUSTING THE TAILSTOCK

Fig. 25

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 63 64

No comments

Delta LA200 Instruction Manual Page 11