Delta 36-L51X Instruction Manual download pdf (Page 13)

Fig. 29

Fig. 30

13. Holding the clear blade guard, lower the saw blade

and assemble the table insert (E) Fig. 30, into the open-

ing on the saw table.

14. Place a straight edge (B) across the table at both

ends of the table insert as shown in Fig. 31.

THE TABLE INSERT (A) SHOULD

ALWAYS BE LEVEL WITH THE TABLE.

If an adjustment is necessary, turn the adjusting screws

(C), as needed, with the 1/8" allen wrench supplied.

Fig. 31

Fig. 33

MOTOR COVER

NOTE: IF YOU HAVE AN “LVC” (STARTER BOX)

VERSION UNISAW, YOU WILL HAVE TO ATTACH

TWO BOTTOM SPRING CLIPS TO THE MOTOR

COVER. IF YOU HAVE AN “GPE” (STARTER BOX)

VERSION UNISAW THE SPRING CLIPS ARE

ALREADY ATTACHED TO THE MOTOR COVER.

1. Attach the two motor cover clips to the motor cover.

Align the hole in the motor cover clip with the hole in the

motor cover. Place a 13/64 flat washer onto a 10-32x1/2"

screw (A), insert screw through the hole in the motor

cover clip and thread screw (A) into the tapped hole in the

motor cover, repeat this process for the remaining motor

cover clip, Fig. 33.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 27 28

No comments

Delta 36-L51X Instruction Manual Page 13