Delta MS450 Instruction Manual download pdf (Page 11)

ATTACHING THE FENCE SLIDE

1. Position the sliding fence (E) Fig. 7C, on top of saw

fence slide support(J). Install thumb screw (K) and

set screw (L) but do not tighten at this time.

2. Slide fence (E) on fence slide support (J) Fig. 7D.

Tighten set screw (L) with hex wrench (M) until it

contacts the fence slide support, then loosen one

turn. The purpose of this set screw is to prevent the

sliding fence from coming completely off the slide

support.

IF SET SCREW (L) IS LEFT TIGHT THE

SLIDING FENCE WILL NOT MOVE.

3. Slide fence to the desired position and tighten thumb

screw (K).

ATTACHING THE WORK CLAMP

Install work clamp assembly (F) Fig. 7E into desired

mounting hole (G). Assemble thumb screw (H) but do not

fully tighten at this time.

MAKE SURE THAT FENCE (M) Fig. 7F

AND WORK CLAMP (N) Fig. 7F ARE CLEAR OF

GUARD AND BLADE (L) Fig. 7F BEFORE OPERATING

SAW.

Fig. 7F

ATTACHING DUST BAG

Depress spring clips (A) Fig. 8, of dust bag (B) and clip

dust bag (B) over rib of dust chute.

Fig. 8

Fig. 7E

Fig. 7C

Fig. 7D

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 22 23

No comments

Delta MS450 Instruction Manual Page 11