Delta 31-695 Instruction Manual

INSTRUCTION MANUAL6" Belt / 9" Disc Sander(Model 31-695)PART NO. 902122 (0112)Copyright © 2001 Delta MachineryESPAÑOL: PÁGINA 21To learn mor

10Fig. 20LOCKING SWITCH INTHE “OFF” POSITIONIMPORTANT: When the machine is not in use, theswitch should be locked in the “OFF” position toprevent unau

11Fig. 24Fig. 25Fig. 26ADJUSTING SANDINGARM STOPA positive stop is provided to position the sanding armlevel with the workbench when the arm is in the

12ADJUSTING TABLE SQUAREWITH SANDING DISC1. DISCONNECT MACHINE FROM POWER SOURCE.2. Using a combination square (C) Fig. 28, place oneend of the square

13Fig. 32Fig. 33Fig. 34Fig. 35ACCESSORY MITER GAGEAn accessory miter gage is available for your machineand is used with the disc table. The miter gage

14Fig. 36Fig. 37Fig. 38Fig. 39ADJUSTING DUST SHIELDIf your sander is connected to a dust collection system,the sander is equipped with a manually oper

15Fig. 40Fig. 41Fig. 42Fig. 435. Slide new 6" x 48" sanding belt (F) Fig. 43, over bothsanding drums (G), making sure the belt (F) will trav

16REPLACING SANDING DISCWhen it becomes necessary to replace the sanding disc, proceed as follows:Fig. 441. DISCONNECT MACHINE FROM POWER SOURCE.2. Lo

17Fig. 49SANDING INSIDE CURVESInside curves can be sanded on the top sanding drum,as shown in Fig. 49.NOTE: Replace sanding drum guard after sandingop

18Two Year Limited WarrantyDelta will repair or replace, at its expense and at its option, any Delta machine, machine part, or machine accessory which

19NOTES

2GENERAL SAFETY RULESWoodworking can be dangerous if safe and proper operating procedures are not followed. As with all machinery, thereare certain ha

20NOTES

3ADDITIONAL SAFETY RULES FORBELT / DISC SANDERSSAVE THESE INSTRUCTIONS. Refer to them often and use them to instruct others. WARNING: FAILURE TO FOLLO

4POWER CONNECTIONSA separate electrical circuit should be used for your machines. This circuit should not be less than #12 wire and shouldbe protected

Use proper extension cords. Make sure your extension cord is in good condition and is a 3-wire extension cord whichhas a 3-prong grounding type plug a

6UNPACKINGYour new Belt/Disc Sander and Stand is shipped complete in one container. Carefully unpack the sander, stand, andall loose items from the sh

7ASSEMBLY INSTRUCTIONSWARNING: FOR YOUR OWN SAFETY, DO NOT CONNECT THE SANDER TO THE POWER SOURCE UNTILTHE MACHINE IS COMPLETELY ASSEMBLED AND YOU REA

8Fig. 8Fig. 9Fig. 11Fig. 12ASSEMBLING BELTAND PULLEY GUARDAssemble belt and pulley guard (A) Fig. 8, to the machineusing two M6 x 55mm hex socket head

9Fig. 13ASSEMBLING LOWERCOVER FOR SANDING DISCAssemble lower cover (A) Fig. 13, to belt and pulleyguard (B) using three M4.2 x 13mm pan head screws (C