Delta (Model 31-300) User Manual download pdf (Page 20)

If you are unfamiliar with kickback, or the consequences that kickback

on the tablesaw presents, DO NOT USE THIS MACHINE.

Never stand or have any part of your body directly in-line with the

cutting path of the saw blade. Stand to the left of your workpiece.

Remove the rip fence when cross-cutting and use miter gauge.

PLEASE-->Avoid cross-cutting large panels on this tablesaw. Use the

panel saw to cut down larger pieces of plywood or paneling, and ﬁnish

cut/miter on the tablesaw.

Always use the fence -or- miter gauge when ripping -or- crosscutting.

The longest dimension of your work piece should always be orientated

against fence or miter gauge when cutting.

Always adjust blade to the proper height above workpiece. About one-

carbide-tip above workpiece.

PLEASE-->Plan your cuts prior to starting. Provide adequate support to

rear and sides of workpiece. Other machines may be more convenient or

safe to use.

Use safety accessories, speciﬁcally push sticks, when cutting. If

slippage or kickback occurs, the push stick will most likely take the damage

that your hand would have received.

Feed cuts through to completion. Anytime you stop feeding the workpiece

in the middle of a cut, the chance of kickback is greatly increased. Work in

teams -or- with your instructor when cutting large stock in order to avoid

kickback potential.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 35 36

No comments

Delta (Model 31-300) User Manual Page 20