Delta UNISAW 36-L352 User Manual download pdf (Page 10)

SECURING SAW TO A PERMANENT

LOCATION

If you desire, you can attach your saw permanently to

the floor by drilling holes at four locations provided in the

base of the saw (two are shown at (A) Fig. 4).

RISK OF INJURY FROM LIFTING. Serious

injury can result from attempting to lift too heavy an

object. The machine is too heavy to be lifted by one

person. Obtain assistance from others before lifting.

PINCH HAZARD. Be sure not place toes or

fingers underneath the base of the Unisaw while moving.

Lift the saw from underneath the table, before assembly,

or the wings and extension table after assembly.

EXTENSION WINGS

NOTE: Be sure to remove switch and switch mounting

hardware from its shipping location. Switch will be

mounted to extension wing.

1. Align the three holes in the one extension wing

with the three holes in the side of the saw table.

Assembled wing shown in Fig. 7.

2. Place an M12 lockwasher on an M12 hex head screw.

Insert the screw through the hole in the extension

wing and thread the screw into the threaded hole

in the side of the table. FINGER TIGHTEN ONLY.

Repeat this process for the two remaining holes in the

extension wing and saw table.

NOTE: Ensure that the front edge of the wing is flush

with or slightly behind the front edge of the table.

3. Use a straight edge to level the extension wing with

the saw table before tightening the three bolts (H)

Fig. 7. Use an 18 mm open-end wrench and start

with a bolt on one side.

4. Align the table and wing making sure they are level

and tighten that side bolt. Move to the middle bolt

and follow the same procedure. Finish with the bolt

on the other end.

5. Place the other extension wing on the other side of

the saw in the same manner.

ASSEMBLY

ASSEMBLY TOOLS REQUIRED

ASSEMBLY TIME ESTIMATE

Assembly for this machine takes approximately 2 hours.

To reduce the risk of injury, turn unit off and disconnect it from power source before installing and

removing accessories, before adjusting or when making repairs. An accidental start-up can cause injury.

• 18 mm and 1/2" open-end or socket wrench (not

supplied)

• 3/16"hex wrench (not supplied)

FIG. 7

FIG. 4

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 107 108

Comments to this Manuals

No comments

Delta UNISAW 36-L352 User Manual Page 10

Comments to this Manuals

Related products and manuals for Power saws Delta UNISAW 36-L352