Delta 22-580 Instruction Manual

13" Two-Speed Finishing Planer(Model 22-580)INSTRUCTION MANUALPART NO. A05724 - 05-20-05Copyright © 2005 Delta MachineryESPAÑOL: PÁGINA 21To lear

10FASTENING PLANER TO SUPPORTING SURFACEDuring operation, if there is any tendency forthe planer to tip over, slide or “walk” across the supportingsur

11The head assembly (A) Fig. 12 contains the cutterhead, feed rollers, chip deflector and motor. Raising and lowering thehead assembly (A) controls th

121. You can use the depth stop (A) Fig. 15 to set thecutterhead to a pre-determined thickness. The stopcan be set at any depth from 1/8" to 6-1/

1. To check and adjust the outfeed roller, make a gaugeblock of hardwood. Follow the dimensions in Fig. 20. 2. Check the knives to be certain that the

14NOTE: One revolution of the cutterhead adjusting handle willmove the cutterhead up or down 1/16".You can make an 1/8" depth of cut in soft

15WRENCH STORAGEYou can store your supplied wrench (A) Fig. 25 in the wrench storage hole (B), located on the left rear side of the machine.Carrying h

16MAINTENANCEThe knives supplied with your planer are double edged andreversible so that you can turn the knives end-for-end whenone edge becomes dull

178. Reverse the knife (H) Fig. 32 or install a new knife.Position the magnetized knife transfer tool (G) on topof knife. Place the knife in the cutte

18You will need to clean the infeed and outfeed rollers (M)Fig. 40 periodically. Use soap, water, and a scotch-britepad.To periodically lubricate the

19PARTS, SERVICE OR WARRANTY ASSISTANCEAll Delta Machines and accessories are manufactured to high quality standards and are serviced by a networkof P

2TABLE OF CONTENTSRead and understand all warnings and operating instructions before using any tool or equipment. Whenusing tools or equipment, basic

20Two Year Limited New Product WarrantyDelta will repair or replace, at its expense and at its option, any new Delta machine, machine part, or machine

The following are trademarks of PORTER-CABLE •DELTA (Las siguientes son marcas registradas de PORTER-CABLE •DELTA S.A.) (Les marquessuivantes sont des

3Indicates an imminently hazardous situation which, if not avoided, will result in death or serious injury.Indicates a potentially hazardous situation

4GENERAL SAFETY RULESREAD AND UNDERSTAND ALL WARNINGS AND OPERATING INSTRUCTIONS BEFOREUSING THIS EQUIPMENT. Failure to follow all instructions listed

5ADDITIONAL SPECIFIC SAFETY RULES1. DO NOT OPERATE THIS MACHINE until it iscompletely assembled and installed according tothe instructions. A machine

6A separate electrical circuit should be used for your machines. This circuit should not be less than #12 wire and shouldbe protected with a 20 Amp ti

7EXTENSION CORDSFOREWORDThe Delta Model 22-580 is a 13" (330mm) Portable Planer that has a cutting capacity of 13" (330mm) wide, 6½"(16

8CARTON CONTENTS1Fig. 21. 13" Two-Speed Finishing Planer2. Cutterhead Adjusting Handle3. Cutterhead Lock HandleASSEMBLYTo attach an optional dust

9Use the supplied wrench to attach the cutterhead lock handle (A) Figs. 3 & 4, to the shaft (B) with the M6-20mm hexsocket-head screw (C) Fig. 4.1