Delta 23-592 Instruction Manual download pdf (Page 6)

2. Align the holes in the eye shield with the holes in the

spark guard and place the eye shield spacer (A) Fig. 7, in

the space in the spark guard as shown.

3. Insert the eye shield bolt (A) Fig. 8, through the hole

in the eye shield (B), eye shield spacer (C), and spark

guard (D).

4. Place an 1/4" flat washer (E) Fig. 8, onto the end of

the eye shield bolt and fasten the eye shield knob (F) to

the end of the eye shield bolt.

5. Assemble the other eye shield in the same manner.

FASTENING GRINDER TO

SUPPORTING SURFACE

IF DURING OPERATION THERE IS ANY TENDENCY

FOR THE GRINDER TO TIP OVER, SLIDE OR

“WALK,” THE GRINDER MUST BE SECURED TO THE

SUPPORTING SURFACE USING FASTENERS (NOT

SUPPLIED) THROUGH THE TWO HOLES (A) Fig. 9, IN

THE GRINDER BASE.

CONNECTING TOOL TO POWER SOURCE

POWER CONNECTIONS

A separate electrical circuit should be used for your tools. This circuit should not be less than #12 wire and should be

protected with a 20 Amp time lag fuse. If an extension cord is used, use only 3-wire extension cords which have

3-prong grounding type plugs and 3-hole receptacles which accept the tool’s plug. Before connecting the motor to the

power line, make sure the switch is in the “OFF” position and be sure that the electric current is of the same

characteristics as indicated on the tool. All line connections should make good contact. Running on low voltage will

damage the motor.

MOTOR SPECIFICATIONS

Your tool is wired for 120 volt, 60 HZ alternating current. Before connecting the tool to the power source, make sure

the switch is in the “OFF” position. The motor provides a no-load speed of 3450 RPM.

GROUNDING INSTRUCTIONS

WARNING: THIS TOOL MUST BE GROUNDED WHILE IN USE TO PROTECT THE OPERATOR FROM

ELECTRIC SHOCK.

Fig. 7

Fig. 8

Fig. 9

1 2 3 4 5 6 7 8 9

No comments

Delta 23-592 Instruction Manual Page 6