Delta 23-725 Instruction Manual download pdf (Page 14)

IMPORTANT: KEEP SPARK GUARDS AND EYE

SHIELDS IN PLACE AT ALL TIMES.

Figures 23, 24, and 25, illustrate several typical

operations that can be accomplished using the grinder.

Each tool rest should be positioned a little below the

center of the grinding wheel and adjusted so the edge of

the tool rest is a distance of 1/8” or less from the wheel.

This will provide maximum support to the piece that is

being ground. This is the most practical and safest

position for general work.

As the grinding wheel wears down to a smaller diameter,

readjust the tool rest closer to the grinding wheel. Always

maintain a distance of 1/8" or less between the grinding

wheel and the edge of the tool rest. Free hand grinding

without the use of the tool rest should always be done on

the lower quarter of the grinding wheel. Read and follow

the “SAFETY RULES” in the front of this manual and

follow them while operating this tool.

Fig. 23

Fig. 24

Fig. 25

Fig. 22

MACHINE USE

DUST PORT

There is one dust port located on the rear of each

grinding wheel cover; this dust port enables the user to

attach a dust collection system to the grinder. Fig. 22.

WHEN USING A DUST COLLECTION

SYSTEM WITH THIS METAL GRINDING

TOOL, BE SURE THE DUST COLLECTOR IS

DESIGNED TO ACCEPT HOT METAL SHAVINGS.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 20

No comments

Delta 23-725 Instruction Manual Page 14