Delta 28-185 Specifications download pdf (Page 4)

ADDiTiONAL SAFETY RULES

FOR BAND SAWS

1, WARNING: Do not operate your band saw until it

is completely assembled and installed according to the

instructions.

2. iF YOU ARE NOT thoroughly familiar with the opera-

tion of band saws, obtain advice from your supervisor,

instructor, or other qualified person.

3. ALWAYS WEAR EYE PROTECTION.

4. MAKE SURE the machine is fastened to a supporting

surface to prevent it from tipping over during operation.

5. NEVER turn the machine "ON" before clearing the

table of all objects (tools, scrap pieces, etc.).

6. NEVER start the band saw with the saw blade pressed

against the workpiece.

7. ADJUST the upper guide about 1/8" above the

materia_being cut.

8. MAKE SURE that blade tension and blade tracking

are properly adjusted.

9. ALWAYS keep hands and fingers away from the

blade.

10. CHECK for proper blade size and type.

11, DO NOT attempt to saw stock that does not have a

flat surface, unless a suitable support is used.

12. HOLD matedal firmly against the table and feed materiat

into blade at a moderate speed.

13. TURN OFF machine if the material is to be backed

out of an uncomp{eted cut.

14. MAKE "release" cuts before cutting long curves

16. STOP the machine before removing scrap pieces

from the table.

t7. NEVER perform layout, assembly, or set-up work on

the table while the machine is operating.

!8. ALWAYS hold the workpiece firmly against the table.

19. AVOID awkward hand positions where a sudden slip

could cause a hand to move into the blade.

20. DO NOT cut material that is too small to be safely

supported.

21. MAKE SURE the blade teeth point downward toward

the table.

22. ALWAYS maintain proper adjustment of blade

tension, blade guides, and blade support bearing.

23. SHUT OFF the power and clean the table and work

area before leaving the machine.

24. SHOULD any part of your band saw be missing,

damaged, or fail in any way, or any electrical component

fail to perform properly, shut off switch and remove plug

from power supply outlet. Replace missing, damaged, or

failed parts before resuming operation.

25. THE USE of attachments and accessories not recom-

mended by Delta may result in the risk of injuries.

26. ADDITIONAL information regarding the safe and proper

operation of this product is available from the National

Safety Council, 1121 Spring Lake Drive, Itasca, IL 60143-

3201, in the Accident Prevention Manual for Industrial

Operations and a_so{r_the Safety Data Sheets prov{ded by

the NSC. Please also refer to the American National

Standards Institute ANS_ 01.! Safety Requirements for

Woodworking Machinery and the U.S. Department of

Labor OSHA 1910.213 Regulations.

t5. DO NOT remove jammed cut-off pieces until blade

has stopped.

27. SAVE THESE INSTRUCTIONS. Refer to them often

and use them to instruct others.

1 2 3 4 5 6 7 8 9 ... 14 15

Comments to this Manuals

No comments

Delta 28-185 Specifications Page 4

Comments to this Manuals

Related products and manuals for Power tools Delta 28-185