Delta 28-278 Instruction Manual download pdf (Page 5)

ATTACHING MOTOR TO STAND

Attach the motor to the stand using four 5/16" x 3/4" carriage bolts (A) Fig. 4 (two of which are shown inserted) through

the motor plate (B) and stand (C). Secure the motor to the stand (Fig. 4) from underneath, using external tooth washers (which

should be placed against the underside of the shelf), flat washers and 5/16" hex nuts (F). NOTE: Partially tighten the motor to

the stand until after belt tension has been adjusted and the pulley has been aligned. Place grommet (D) in large hole in top shelf

(Fig. 4). Insert switch cord and power cord (E) through the hole.

CARTON CONTENTS

ASSEMBLY

ASSEMBLING STAND

Begin the assembly of the stand (Fig. 1) by inserting sixteen 5/16-18 x 5/8" carriage bolts (A) (eight of which are shown)

through the holes in the legs (B) and the holes in the short and long tie bars (C). Secure this part of the assembly by attaching

5/16" hex nuts from the inside. Place the shelf (D) on the inside of the legs, and insert eight 5/16x18 carriage bolts (E) through

the legs (B) and shelf (D). Secure the shelf with flat washers, lock washers and 5/16" hex nuts from the inside. Partially tighten

the hardware at this point.

The top view of the shelf (Fig. 2) illustrates the 4 holes (F) that are used to mount the saw to the stand, and the 4 holes (G) that

are used to mount the motor to the stand. The power cord and the motor-to-switch cord pass through the large hole (H) so that

they are down and out of the way.

Fig. 1

Fig. 2

ATTACHING BAND SAW TO STAND

Attach the band saw (A) Fig. 3 to the stand (B) Fig. 3, using the four 5/16-18 x 1-3/4" hex head screws (two of which are shown

at (C), flat washers, lockwashers and 5/16"-18 hex nuts. Place the hex head screws and lockwashers through the tool base and

the stand. Secure with lock washers and hex nuts from underneath. Push down on top of the stand so that the legs of the stand

adjust to the surface of the floor. Tighten all of the hardware.

Fig. 4

The Delta Model 28-278 comes packaged with the saw, stand, motor, belt and belt guard, pulleys, and hardware.

Fig. 3

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Delta 28-278 Instruction Manual Page 5