Delta 37-071 Instruction Manual download pdf (Page 15)

FIGURE 18

TO CALIBRATE THE 45° INWARD AND OUTWARD STOPS:

OPERATION

1. Loosen the beveling lock by rotating the handle

counterclockwise.

2. Refer to Figure 18 and locate the two sets of 45°

Stop Bolts (A), there are two bolts that set the

position for the inward 45° Stop and two that set

the position for the outward 45° stop.

3. Loosen the two retaining nuts on the appropriate

set of Stop bolts and adjust the Stop bolts either in

or out.

NOTE: The heads of both Stop bolts must be flush

against the mount assembly.

4. Re-tighten the retaining nut and re-lock the

beveling lock. Then re-check the angle using the

carpenter’s square. Continue to adjust as needed.

DEPTH ADJUSTMENT

Disconnect the machine from the

power source before making any

adjustments!

The DELTA

37-071 Bench Jointer is designed to

remove no more than 1/8” of stock in a single pass. For

operations requiring the removal of more stock, make

several passes to achieve the desired dimensions.

1. To adjust the depth of cut, rotate the infeed table

height adjustment wheel. Turning the wheel

clockwise raises the table (reducing the depth of

cut) while rotating it counterclockwise lowers the

table (increasing the depth of cut).

1 2 ... 10 11 12 13 14 15 16 17 18 19 20 ... 55 56

No comments

Delta 37-071 Instruction Manual Page 15