Delta 43-290C Instruction Manual download pdf (Page 8)

Fig. 11

Assembling and Changing Spindles

DISCONNECT TOOL FROM POWER SOURCE.

Figure 11

Thread the end of the tie rod with the shorter threads (A)

into the spindle bottom (B). Insert tie rod and spindle into

the spindle cartridge, making sure the notches in the spindle

nut (E) on the bottom end of tie rod.

Figure 12

Place the special wrench on top spindle flats (A). Tighten

tie rod nut (B) with supplied open end wrench.

Figure 13

There are four different collars supplied with both the 1/2”

spindle and the 3/4” spindle. These collars allow the cutter

to be positioned at various locations on the spindle. When

assembling cutters to a spindle, place the cutter as close

to the bottom as possible. This reduces the chance of

spindle run-out. With the cutter and collar selections in place,

thread the RIGHT threaded hold down nut (A) onto spindle

and tighten. Next thread the LEFT threaded locking nut (B)

onto spindle and tighten.

Fig. 12

Fig. 13

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

No comments

Delta 43-290C Instruction Manual Page 8