Delta 43-424 Instruction Manual download pdf (Page 7)

ASSEMBLY INSTRUCTIONS

WARNING: FOR YOUR OWN SAFETY, DO NOT CONNECT THE SHAPER TO THE POWER SOURCE

UNTIL THE SHAPER IS COMPLETELY ASSEMBLED AND YOU HAVE READ AND UNDERSTOOD THE

ENTIRE INSTRUCTION MANUAL.

Fig. 5

Fig. 6

Fig. 8Fig. 7

ASSEMBLING SPINDLE

RAISING AND

LOWERING HANDWHEEL

1. Insert key (A) Fig. 5, into slot in spindle raising and

lowering shaft (B) as shown.

2. Assemble handwheel (C) Fig. 5, onto spindle shaft

(B), making certain the key (A) fits into the slot (D) in the

handwheel. Insert the set screw which holds the

handwheel to the shaft and tighten screw firmly against

key.

3. Thread lock knob (E) Fig. 6, into the spindle shaft (B).

ASSEMBLING EXTENSION WINGS TO SHAPER TABLE

1. Assemble extension wing (A) Fig. 7, to shaper table (B) using three 1-1/4" inch-long hex head screws (C) and flat

washers (D) supplied. Use a straight edge (E) Fig. 7, to make certain the extension wing is level with shaper table before

tightening three screws (C). Assemble and level remaining extension wing in the same manner.

2. Fig. 8, illustrates both extension wings assembled to shaper table.

1 2 3 4 5 6 7 8 9 10 11 12 ... 26 27

No comments

Delta 43-424 Instruction Manual Page 7