Delta BS220LS Instruction Manual download pdf (Page 7)

ASSEMBLY

FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL

THE MACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE ENTIRE

INSTRUCTION MANUAL.

STAND

1. Assemble stand as shown in Fig. 3, using parts

shown in Fig. 2. The braces, legs and feet are numbered

the same in both illustrations. Insert the M8x1.25x16mm

carriage head screws through legs and braces then

place the 3/8" flat washers on the screws and secure

with the M8x1.25 hex nuts. Only tighten nuts finger-tight

at this time. NOTE: The top lips of the side braces (2)

Fig. 3, must fit on top of the front and rear braces (3).

The top lips of the side braces (4) Fig. 3, must fit on top

of the front and rear braces (5).

2. Attach the four plastic feet (11) Fig. 3, to the bottom

of each leg (6).

Fig. 3

BAND SAW

TO STAND

1. Fig. 4 illustrates the two through holes (A) and two

threaded holes (C) which will be used to secure the band

saw to the stand.

2. Place the band saw on top of stand and line up the

two threaded holes (C) Fig. 4, with the two holes (D) Fig.

5, on upper brace of stand.

Fig. 4

Fig. 5

1 2 3 4 5 6 7 8 9 10 11 12 ... 20 21

No comments

Delta BS220LS Instruction Manual Page 7