Delta Delta JT360 Instruction Manual download pdf (Page 22)

22 - English

Do not perform jointing operations on

material shorter than 10" (254 mm), narrower than

3/4" (19 mm), or less that 1/2" (12.7 mm) thick. See

Fig. 66.

JOINTING AN EDGE

This is the most common operation for the jointer. Set

the guide fence square with the table. Depth of cut

should be the minimum required to obtain a straight

edge. Hold the best face of the piece firmly against the

fence throughout the feed as shown in Fig. 65. Maximum

depth of cut should not be more than 1/8" (3.175 mm)

in one pass.

DEFINITIONS OF JOINTING AND PLANING OPERATIONS

1. JOINTING OPERATIONS – Jointing cuts or edge

jointing are made to square an edge of a workpiece.

The workpiece is positioned on the jointer with the

narrow edge of the workpiece on the infeed table and

the major flat surface of the workpiece against the

fence, as shown in Fig. 62. The workpiece is moved

from the infeed table, across the cutterhead to the

outfeed table.

2. PLANING OPERATIONS – Planing or surfacing

are identical to the jointing operation except for the

position of the workpiece. For planing, the major

flat surface of the workpiece is placed on the

infeed table of the jointer with the narrow edge of

the workpiece against the fence, as shown in Fig.

63. The workpiece is moved from the infeed table,

across the cutterhead to the outfeed table. Use push

blocks when performing planing operations whenever

possible.

Fig. 65

WORK

OUT-FEED

TABLE

IN-FEED TABLE

CUTTER

Fig. 64

Fig. 63Fig. 62

3/4" (19 mm) MIN I MUM

10" (254 mm) MINIMUM

MINIMUM JOINTING

DIMENSIONS

1/2" (12.7 mm)

MIN I MUM

Fig. 66

1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 75 76

Comments to this Manuals

No comments

Delta Delta JT360 Instruction Manual Page 22

Comments to this Manuals

Related products and manuals for Power tools Delta Delta JT360