Delta DP115 Instruction Manual download pdf (Page 8)

Fig. 10

5. Thread the three pinion shaft handles (H) Fig. 8, into

the three holes located in the pinion shaft (J) as shown.

Fig. 8

Fig. 9

6. IMPORTANT: Make certain the spindle taper (K) Fig.

9, and tapered hole in chuck (L) are clean and free of any

grease, lacquer or rust preventive coatings. NOTE:

Household oven cleaner can effectively remove any sub-

stance from the spindle and chuck; however, carefully

follow the manufacturer's safety rules concerning its

use.

7. IMPORTANT: Open the chuck jaws as wide as

possible by turning the chuck sleeve (M) Fig. 10.

8. Holding chuck on taper of spindle, tap with a soft tip

hammer (N) or a block of wood and hammer to set

chuck, as shown in Fig. 10. IMPORTANT: To avoid

damage to the chuck, NEVER drive the chuck onto the

spindle with a metal hammer.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

No comments

Delta DP115 Instruction Manual Page 8