Delta JT160 Instruction Manual download pdf (Page 11)

Fig. 15

Fig. 16

CUTTERHEAD LOCK

Assemble cutterhead lock (A) Fig. 15 to the front side of the jointer base, using the M6x1x12mm button head screw

(B).

NOTE: THE CUTTERHEAD LOCK (A) IS TO BE ENGAGED WITH THE CUTTERHEAD SHAFT (FIG. 15) ONLY

WHEN SETTING KNIVES. ALL OTHER TIMES, THE CUTTERHEAD LOCK (A) SHOULD BE DISENGAGED FROM THE

CUTTERHEAD (FIG. 16).

FASTENING JOINTER TO SUPPORTING SURFACE

If during operation, there is any tendency for the jointer

to tip over, slide or "walk" on the supporting surface,

the jointer must be secured to the supporting surface.

Four holes (two of which are shown at (A) Fig. 20), are

provided for this purpose.

Fig. 20

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 55 56

No comments

Delta JT160 Instruction Manual Page 11