Delta MM300 Instruction Manual download pdf (Page 9)

5. Insert bar of fence assembly (E) Fig. 11, through

hole in column as shown. Tighten handle (C) against flat

on fence bar to hold fence in position. NOTE: Handle (C)

is spring-loaded and can be repositioned on the stud

located underneath the handle by pulling out the handle

and repositioning it on the stud.

Fig. 11

Fig. 12

6. Insert bar (F) Fig. 12, into hole on top of fence as

shown, and tighten set screw (G) against flat on bar (F).

Fig. 13

7. Assemble the holddown (H) Fig. 13, onto bar (F) as

shown, and tighten set screw (J) against flat on bar.

Fig. 14 Fig. 15

TOOL AND CHISEL HOLDER

1. Assemble tool and chisel holder (A) Fig. 14, to side

of column using the two M6x1x25mm screws (B) and

M6 flat washers as shown.

2. Fig. 15, illustrates the chuck key (C), wrench (D) and

chisels and bits (E) in holes of tool and chisel holder (A)

when not in use.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 17 18

No comments

Delta MM300 Instruction Manual Page 9