Delta ShopMaster SM300 Instruction Manual

INSTRUCTION MANUALRouter / Shaper(Model SH100)PART NO. 905582 - 05-15-02Copyright © 2002 Delta MachineryESPAÑOL: PÁGINA 19To learn more about DELTA MA

10OVERLOAD PROTECTIONThe Router/Shaper is equipped with overload protection.If the motor shuts off, or fails to start due to overloading(cutting stock

11Fig. 20Fig. 21AAFig. 22ABFig. 23CABSEE-THRU CUTTER GUARDThe see-through cutter guard (A) Fig. 20, should alwaysbe used when using the fence to guide

125. Loosen adjustment bolt (D) Fig. 24, andcorresponding bolt at the rear of the machine (notshown.).6. Carefully move the spindle height lock knob (

13Fig. 27Fig. 28Fig. 29Fig. 30ADCHEFGABBAAKBINSTALLING ROUTER BITS1. DISCONNECT MACHINE FROM POWER SOURCE.2. Raise spindle to the maximum height and t

14INSTALLING OVERHEADCUTTER GUARDAn overhead cutter guard, shown in Fig. 31, is suppliedas standard equipment with your Router/Shaper andshould always

15OPERATIONThe following is an example of the setting-up and operational procedures when using the fence, collars andstarting pin. Please review this

16POSITION OF COLLARS1. The collars may be used in any of the following po-sitions: above, below or between two cutters.2. When the collar is used bel

17NOTES

Two Year Limited WarrantyDelta will repair or replace, at its expense and at its option, any Delta machine, machine part, or machine accessory whichin

2GENERAL SAFETY RULESWoodworking can be dangerous if safe and proper operating procedures are not followed. As with all machinery, thereare certain ha

3ADDITIONAL SAFETY RULES FORFOR THE ROUTER/SHAPERWARNING: FAILURE TO FOLLOW THESE RULES MAY RESULT IN SERIOUS PERSONAL INJURYFig. B21. USE A HEAVY WOR

4POWER CONNECTIONSA separate electrical circuit should be used for your machines. This circuit should not be less than #12 wire and shouldbe protected

Use proper extension cords. Make sure your extension cord is in good condition and is a 3-wire extension cord whichhas a 3-prong grounding type plug a

6ROUTER / SHAPER PARTSFig. 21. Router / Shaper2. 1¼" Open End Arbor Wrench3. Collet Wrench4. 3mm Hex wrench5. Left Hand Fence Body6. Right Hand F

7ASSEMBLYWARNING: FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTILTHE MACHINE IS COMPLETELY ASSEMBLED. DO NOT OPERATE THIS MA

8Fig. 10PSAHFENCE ASSEMBLY ANDDUST CHUTETwo fence halves are supplied as standard equipmentwith the Router/Shaper. To assemble and install thefence as

9ASSEMBLINGTABLE INSERTThe table insert (A) is assembled in the table, as shownin Fig. 11.Fig. 11FASTENINGROUTER/SHAPERTO SUPPORTINGSURFACEIF DURING O