Delta ts200ls Instruction Manual download pdf (Page 21)

Fig. 42

Fig. 43

THE MAXIMUM WIDTH DADO CUT FOR

THIS SAW IS 1/2 INCH.

THE BLADE GUARD AND SPLITTER

ASSEMBLY CANNOT BE USED WHEN DADOING. IT

MUST BE REMOVED OR SWUNG TO THE REAR OF

THE SAW.

Before dadoing, loosen wing nut (A) Fig. 44 and take off

the blade guard and splitter assembly (B). Keep

assembly handy to replace it after dadoing.

AUXILIARY JIGS, FIXTURES, PUSH

STICKS AND FEATHER BOARDS SHOULD BE USED.

ACCESSORY DADO CUTTERHEAD

than three feet, use a work support at the rear of the

saw to keep the workpiece from falling off the saw

table.

3. If the ripped work is less than 6 inches wide, a push

stick should always be used to complete the feed, as

shown in Fig. 41. The push stick can easily be made

from scrap material as explained in the section

“CONSTRUCTING A PUSH STICK.”

4. Ripping narrow pieces can be dangerous if not done

carefully.

WHEN THE PIECE IS TOO NARROW

FOR A PUSH STICK TO BE EFFECTIVE - AND IF THE

WORKPIECE IS SHORT ENOUGH - USE A

PUSHBOARD. WHEN RIPPING MATERIAL UNDER 2

INCHES IN WIDTH, ORDINARY PUSH STICKS MAY

INTERFERE WITH THE BLADE GUARD.

When using a pushboard, the width of the pushboard

must be added to the width of the rip fence position

setting. A flat pushboard can be constructed as shown in

Fig. 43 and should be used as shown in Fig. 42. NOTE:

GUARD REMOVED FOR CLARITY. ALWAYS USE THE

GUARD.

NOTE: Some special operations require the addition of

an auxiliary wood facing to the fence, as explained in the

section “USING AUXILIARY WOOD FACING ON THE

RIP FENCE” and use of a push stick.

Fig. 43A

USING AUXILIARY WOOD FACING

ON RIP FENCE

When performing special cutting operations – and that

operation may cause the cutting implement to contact

the fence – it is necessary to add a wood facing (A) Fig.

43A, to one side of the rip fence as shown. The wood

facing is attached to the fence with wood screws through

holes drilled in the fence. 3/4-inch stock is suitable for

most work, although an occasional job may require one-

inch facing.

Fig. 44

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 51 52

Comments to this Manuals

No comments

Delta ts200ls Instruction Manual Page 21

Comments to this Manuals

Related products and manuals for Power tools Delta ts200ls