Delta T14001-PNT2O-LHP Installation Guide download pdf (Page 4)

14 T20 Series Installation

2

Cartridge Installation

C.

Turn off water supplies. Remove

cover (1) and bonnet nut (2) from the

body, if necessary. If this is not a thin

wall mounting, the entire plasterguard (3)

may be removed.

For back to back or reverse installations

(hot on right and cold on left) insert the

cartridge with the ‘C’ on the left. If you

are not making a reverse or back to back

installation skip this step and continue

with step 2C.

Slide bonnet nut (1) over the wire and car-

tridge (2) and thread onto the body. Hand

tighten securely. Note: After bonnet nut

is installed, verify the valve is in the off

position. Rotate stem clockwise.

B.

Back to back Installation

Normal Installation (changes not required)

Reverse

Installation

Cold

Hot

1

4

4

3

1

6

A.

1

2

3

Rotate the cartridge (1) so the letter ‘C’

(2) appears on the right. Insert cartridge

into valve body as shown. Make sure

the cartridge tubes and O-rings (3) are

properly seated in holes at the base of the

body. Ensure the keys on the body are fully

engaged with the slots in the body (4).

2

14 T20 Series Installation

A.

B.

If your model requires a spacer (1), insert

it into the sleeve (2) and push it to the

front. Slide the sleeve over the cartridge,

body and O-ring. Caution: Do not

damage the wire during installation

of the sleeve.

1

2

1

2

Slide O-ring (1) over cartridge, wire and

the bonnet nut (2). The O-ring, which acts

as a spacer to steady the sleeve, should

rest behind the bonnet nut.

1

2

3

F

C

C.

D.

Mount the backplate onto body using

screws (1) provided. Do not over

tighten screws.

1

1

2

Connect wire from cartridge (1) to back

side of backplate (2). Note: Switch (3) is

used to change the temperature from

Celsius to Fahrenheit.

F

C

3

7

Backplate and Trim Installation

1 2 3 4 5 6 7 8 9 ... 17 18

Comments to this Manuals

No comments