Delta 46-755X User Manual download pdf (Page 12)

4. To stop the spindle without turning the power off, press

the stop button (C) Fig. 22 on the control panel.

5. To restart, press the FWD button (B). The spindle will

gradually return to the speed at which it was stopped.

6. The REVERSE (REV) button (D) Fig. 22 will reverse

the spindle rotation.

NOTE: When using the faceplate, tighten the faceplate

locking screw (A) Fig. 23.

NOTE: To remove the faceplate, loosen the set screw

(A) Fig. 23 two full turns. Engage the spindle

lock (C) and use the supplied wrench (B) Fig. 24

to loosen the faceplate. Remove the face plate

from the spindle.

NOTE: Use the chart (B) Fig. 25A on the front of the

door for safe operation.

IMPORTANT: For emergencies, use ONLY the safety

cover to stop the machine. Also, when leaving the

machine, lower the safety cover, and cut the power to

the adjustable speed drive. The control is still energized

as long as the power switch is on.

NOTE: To lock the spindle or to utilize the indexing fea-

ture, pull the spindle lock pin (A) Fig. 25 out and rotate

the pin clockwise. Re-engage it in the pulley holes (B)

Fig. 25, some of which are shown. The spindle pulley

has 24 holes accurately spaced around the rim of the

pulley. This feature makes it possible to make evenly

spaced divisions on turnings which could be fluted,

grooved, or to mark places to be drilled.

Fig. 22

Fig. 23

Fig. 24

Fig. 25

CHANGING ACCELERATION/DECELERATION

To change the acceleration/deceleration rate, loosen the

screw (A) Fig. 25A and open the door.

This machine has two different start-up speeds. For

larger workpieces, move the switch (A) Fig. 25 B to the

“up” position. For smaller workpieces, move the switch

to the “down” position.

Fig. 25A

Fig. 25B

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 23 24

No comments

Delta 46-755X User Manual Page 12