Delta 50-761 User Manual download pdf (Page 9)

FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL

THE MACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE ENTIRE INSTRUCTION

MANUAL.

ASSEMBLY

CASTERS

1. Turn stand (A) upside down, as shown in Fig 1C.

2. Place 3/8” lockwasher on caster stud (B) and

screw caster into threaded hole on the bottom of

the stand. Repeat for other three casters.

3. Tighten caster by hand, then set with a thin 14mm

wrench.

Fig. 1C

ATTACHING STAND TO LEGS ON

MOTOR/BLOWER ASSEMBLY

NOTE: TWO PEOPLE ARE NEEDED FOR THIS STEP.

Place all four stand posts (A) Fig. 3 into four legs (B) on

motor/blower assembly. Make sure metal base plates

(D) are arranged over the large dust collection holes

(C).

Fig. 3

LEGS TO MOTOR/BLOWER

ASSEMBLY

1. Place motor/blower assembly with the motor (A)

Fig. 2 down.

2. Place 5/16” flatwasher on knob (B).

3. Align holes on legs (C) with holes (D) in the

motor/blower assembly. Legs should extend up.

Insert knob through hole in the legs (C) and into

threaded hole in the motor/blower assembly (D).

Tighten knob securely.

4. Repeat steps for all knobs on both legs.

Fig. 2

THIS MACHINE IS HEAVY. USE TWO

OR MORE PEOPLE WHEN LIFTING.

ASSEMBLY TOOLS REQUIRED

ASSEMBLY TIME ESTIMATE - 30 minutes to 1 hour

* Phillips head screwdriver * 12 mm wrench

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

No comments

Delta 50-761 User Manual Page 9