Delta 46-755X User Manual download pdf (Page 11)

STARTING AND STOPPING THE

TOOL

The power switch, located under the safety cover (B) Fig. 18

provides electrical power to the adjustable speed drive. Lift

the safety cover (B) and move the switch up to the “ON”

position. To turn the power off, push the safety cover (B)

down.

Fig. 18 shows the switch with safety cover down in the

“OFF” position. Fig. 19 shows the lathe in the “ON” position

(switch cover (A) up and switch (B) up).

NOTE: In case of emergency, immediately push the safe-

ty cover (B) down to shut off power.

These machines have a circuit that automat-

ically decelerates the spindle once you push

the stop button (C) Fig. 22 on the control

panel. Although an optional dynamic brake

is mentioned in the manual provided with

the Baldor Adjustable Speed Controller,

Delta does not recommend the use of any

optional brake systems on the lathe. Further,

DO NOT CHANGE OR ADJUST the con

troller settings that have been pre-set at the

factory.

LOCKING SWITCH IN THE

“OFF” POSITION

IMPORTANT: When the tool is not in use, the switch should

be locked in the “OFF” position to prevent unauthorized

use, using a padlock (A) Fig. 20 with a 3/16” diameter shack-

le inserted through the holes in the switch plate (C) Fig. 19.

ACTIVATING THE SPINDLE

Even though power may be going to the adjustable speed

drive, the spindle will not turn until you activate it.

1. Before activating the spindle, tighten and clear all

clamps, bolts, etc. Turn the workpiece by hand to see

that it clears the tool rest and to make sure that the spin-

dle lock is in the UNLOCKED position (A) Fig. 21.

2. Prior to activating the spindle, set the speed control

knob (A) Fig. 22 to the “zero” position.

Input voltage must be 200 to 240 single

phase. Other voltage will cause severe dam-

age to the inverter.

3. After turning the power switch on, push the “run” button

(B) Fig. 22. Then slowly turn the knob (A) clockwise to

the desired speed.

NOTE: The numbers in the display multiplied by 10 will indi-

cate the spindle speed.

Fig. 21

Fig. 19

Fig. 20

Fig. 18

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 23 24

Comments to this Manuals

No comments

Delta 46-755X User Manual Page 11

Comments to this Manuals

Related products and manuals for Tools Delta 46-755X