Delta 50-763 User Manual download pdf (Page 8)

ASSEMBLY

For your own safety, do not connect the machine to the power source until the machine is

completely assembled and you read and understand the entire instruction manual.

ASSEMBLY TOOLS REQUIRED

ASSEMBLY TIME ESTIMATE

Phillips head screwdriver 12 mm wrench

This machine is heavy. Use two or more people when lifting.

1. Turn the stand (A) upside down (Fig 1).

2. Align the holes in the caster assembly (B) with the

holes in the plates on the stand. Place a 5/16”

flatwasher on a 5/16” x 3/4” hex-head screw. Place

this screw through the hole in the caster assembly.

and thread it into the hole in the stand. Attach the

other caster assemblies in the same manner.

3. Tighten the hardware by hand and then set it with

a 12mm wrench.

NOTE: This step requires two people.

Place all four stand posts (A) Fig. 3 into the four legs

(B) on the motor/blower assembly. Make sure that the

metal base plates (D) are arranged over the large holes

in the dust collector (C).

1. Place the motor/blower assembly with the motor (A)

Fig. 2 down.

2. Place a 3/8” (18 mm) flatwasher on the knob (B).

3. Align the holes on the legs (C) with the holes (D) in

the motor/blower assembly with the legs extending

up. Insert the knob through the hole in the legs

assembly (D). Tighten the knob securely.

4. Repeat for all knobs on both legs.

ATTACHING THE LEGS ON THE MOTOR/BLOWER ASSEMBLY

ATTACHING THE CASTERS

ATTACHING THE STAND TO THE LEGS ON THE MOTOR/BLOWER ASSEMBLY

30 minutes to 1 hour

Fig. 1

Fig. 2

Fig. 3

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 43 44

No comments

Delta 50-763 User Manual Page 8