Delta 50-851 User Manual download pdf (Page 5)

Fig. 4

Fig. 5

Fig. 6

Fig. 7

ASSEMBLING CASTER

ASSEMBLIES TO BASE

1. Align the holes in swivel caster assembly (A) Fig. 4,

with four holes in caster bracket (B) located on the

underside of base (C). Place a 5/16" lockwasher (E) Fig.

4 onto a 5/16-18x5/8" hex head screw (D), then place a

5/16" flat washer (F) onto the hex head screw. Insert the

hex head screw through the hole in the wheel caster,

thread the hex head screw into the tapped hole in the

base, and tighten securely. Repeat this process for the

three remaining holes. Assemble the three remaining

swivel caster assemblies to the base in the same

manner.

2. Fig. 5, illustrates the caster assembled to the base.

ASSEMBLING BLOWER AND

MOTOR ASSEMBLY TO BASE

1. Set blower and motor assembly (A) Fig. 6, on base (B).

2. Align mounting holes (C) Fig. 6, at the bottom of blower

and motor assembly (A) with four threaded holes in the

base, three of which are shown at (D). Place a 5/16"

lockwasher (F) Fig. 6, onto a 5/16-18x5/8" hex head

screw (E), then a 5/16" flat washer (G) onto the hex head

screw. Insert the hex head screw through the hole in the

motor assembly, thread the screw into the hole in the

base, and tighten securely. Repeat this process for the

three remaining holes.

3. Fig. 7, illustrates the blower and motor assembly (A)

fastened to the base.

4. Apply a bead of silicone sealant around the blower

flange (H) Fig. 7.

ASSEMBLY

WARNING: FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL THE

MACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE ENTIRE INSTRUCTION

MANUAL.

1 2 3 4 5 6 7 8 9 10 11 12

No comments

Delta 50-851 User Manual Page 5