Delta 28-348 Instruction Manual download pdf (Page 9)

ASSEMBLY

FOR YOUR OWN SAFETY, DO NOT CONNECT THE MACHINE TO THE POWER SOURCE UNTIL

THE MACHINE IS COMPLETELY ASSEMBLED AND YOU READ AND UNDERSTAND THE ENTIRE

INSTRUCTION MANUAL.

MOTOR BRACKET

TO CABINET

1. Place the cabinet on its side as shown in Fig. 6.

Fig. 6

2. Align the two holes in the motor bracket (A) Fig. 7,

with the two holes in the cabinet. NOTE: ATTACH

MOTOR BRACKETS TO HOLES #2 AND 4 IN FRONT

CABINET FLANGE (D) FIG. 6, AND HOLES #4 AND 6

IN REAR CABINET FLANGE (E).

NOTE: MAKE SURE THE SLOTS (C) FIG. 7, IN THE

MOTOR BRACKET (A), ARE POSITIONED CLOSER

TO THE OPENING OF THE CABINET (D) THAN THE

BACK PANEL (E) OF THE CABINET.

3. Insert 5/16-18x3/4" carriage head bolts through the

holes in the motor brackets (A) Fig. 7, and the holes in

the cabinet.

4. Thread 5/16-18 flange hex nuts onto the screws and

tighten securely.

Fig. 7

MOTOR TO

MOTOR BRACKET

1. Place the motor (B) Fig. 8, on the motor brackets (A).

Align the holes in the motor mounting plate with the

holes on the motor brackets.

2. Insert 5/16-18x3/4" carriage head bolts through the

holes in the motor brackets and the holes in the motor

mounting plate.

3. Thread 5/16-18 flange hex nuts on to screws.

NOTE: DO NOT COMPLETELY TIGHTEN THE

HARDWARE AT THIS TIME.

4. Place cabinet on its base as shown in Fig. 9.

Fig. 8

Fig. 9

34 5

2 3 4

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 27 28

No comments

Delta 28-348 Instruction Manual Page 9