Delta 40-530 Specifications download pdf (Page 9)

Notes on installation

Configurations:

stacked or side-by-side

Sections for stacked configurations are delivered to site separately and must be

secured together on site with the aid of the enclosed self-tapping screws (KG 40-

250) or enclosed accessories (KG/KGW 630-1000).

The sections which make up the stacked or side-by-side configuration cannot be

secured together until the various transportable units have been installed on site

in their final positions.

To facilitate assembly on site, the frame of the bottom section for a stacked

configuration or one side section for a side-by-side configuration is pre-drilled ex-

works to accommodate the self-tapping screws. After securing the sections

together, do not forget to fit the enclosed plastic caps to the tips of the self-tapping

screws (KG 40-250).

An adhesive label on the face of the skinning panel bearing the words “Zur

Gerätemontage Verkleidungsplatte abnehmen” (remove panel for assembly)

indicates the positions of the pre-drilled holes.

The unit is delivered to site fully assembled. The sections can be separated for

handling and reassembled at the final location.

The sectional frames of a separable unit are in two parts held together by a steel

flat or an angle.

Separating the sections of a KG 40-250 entails removing the frame insulation (if

fitted). Do not forget to reinstall the insulation before bolting the cubes together.

For separation

(on request)

Plastic cap

Frame, top section

Frame, bottom section

Self-tapping screw

KG 40-250 KG 630-1000

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 19 20

No comments

Delta 40-530 Specifications Page 9