Delta CL180CS Instruction Manual download pdf (Page 11)

3. Place the outer blade flange on the arbor with the flange toward the

blade. Mate the flats with those on the arbor.

4. Replace the blade retaining bolt and finger tighten by turning counter-

clockwise.

5. Push in the arbor lock and rotate the blade arbor by hand until the lock

engages the arbor. Tighten the blade retaining bolt with the blade wrench (C)

Fig. 6 just enough to prevent blade slippage during normal cutting, and

release the arbor lock.

TELESCOPING GUARD

The telescoping guard (E) Fig. 10 is an important safety device. Each time you

use the saw, see that the telescoping guard rotates freely and returns quickly

and completely to its closed position. Frequently check the retracting spring

(F) Fig. 10 to see that it is functional and free of debris. At least once a month,

remove any accumulated sawdust, pitch, or other debris from the area around

the hub (G) Fig. 10 of the telescoping guard, and add a few drops of light

machine oil at each end of the hub. NEVER block or wedge the telescoping

guard in the open position.

DO NOT use your saw if the telescoping guard is not in work-

ing order. If the telescoping guard movement is sluggish or binding exists, take

the saw to your nearest AUTHORIZED DELTA SERVICE STATION or DELTA

SERVICE CENTER for repair.

Fig. 10

Fig. 11

TO ADJUST DEPTH OF CUT

Adjust the depth of cut so that the saw blade just protrudes through the thick-

ness of workpiece being cut.

REMOVE THE BATTERY.

1. Loosen the depth adjusting knob (H) Fig. 11 at the rear of the saw.

2. Raise or lower the saw housing until the blade extends the desired dis-

tance below the workpiece.

Fig. 12

NOTE: The depth adjusting segment

(J) Fig. 12 is marked in 1/8" incre-

ments. Aligning the required marking

with the lower edge of the housing

will produce the approximate depth

of cut desired.

3. Tighten the depth adjusting

knob firmly, locking the saw in the

selected position.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17

No comments

Delta CL180CS Instruction Manual Page 11