Delta ShopMaster A05581 Instruction Manual download pdf (Page 10)

STAND ASSEMBLY

1. Assemble the stand as shown in Fig. 4A, using 16

carriage bolts, flat washers and hex nuts. Do not

completely tighten the hardware at this time. Letters are

stamped on the stand brackets for ease in assembly.

A - Top front and rear brackets

B - Top side brackets

C - Bottom side brackets

D - Bottom front and rear brackets

IMPORTANT: THE TOP FRONT AND REAR

BRACKETS (A) FIG. 4A, ARE LONGER THAN THE

TOP SIDE BRACKETS (B) FIG. 4A. THE BOTTOM

FRONT AND REAR BRACKETS (D) FIG. 4A, ARE

LONGER THAN THE BOTTOM SIDE BRACKETS (C).

2. Assemble the rubber feet (E) Fig. 4A, to the bottom of

each leg (F) as shown. NOTE: Each rubber foot is

provided with holes for mounting the stand to the floor

surface if required.

SAW TO STAND

1. Turn saw table face down on a piece of cardboard to

protect the table surface. Place stand upside down onto

saw and align the four holes in the stand with the

mounting holes in the saw.

2. Place a 3/8" flat washer on a M8x1.25x40mm hex

head screw. Insert the hex head screw through the

mounting hole in the saw and the mounting hole in the

stand. Place another 3/8" flat washer on the hex head

screw and thread a M8x1.25 hex nut on the screw and

loosely tighten. Complete this process for the other

three holes.

3. Then, turn saw table face up, as shown in Fig. 4B

(Saw is shown fully assembled here).

3. Push down on top of the saw so the legs of the stand

adjust to the surface of the floor and tighten all stand

hardware and hardware which secures saw to stand.

Fig. 4A

Fig. 4B

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 28 29

No comments

Delta ShopMaster A05581 Instruction Manual Page 10