Delta ShopMaster A05581 Instruction Manual download pdf (Page 17)

OUTFEED SUPPORT

1. Loosely fasten both brackets (A) Fig. 31, to the

bottom left side of the saw table as shown, using two

M6x1x15mm hex head screws (B) and M6.1

lockwashers (C). Assemble two remaining brackets to

the bottom right side of saw table in the same manner.

2. Insert rod (D) Fig. 32, through holes in brackets (A) as

shown. Then thread and tighten one 1/4-20x1/2" hex

head screw (E) and 1/4" flat washer (F) into the front end

of rod (D) as shown at (G). Assemble remaining rod to

the opposite side of saw in the same manner.

3. Insert rods (D) Fig. 33, into larger holes (H) in outfeed

support (J) as shown.

4. Secure outfeed support (J) Fig. 34, to rods (D) using

two 1/4-20x1/2" hex head screws and 1/4" flat washers

(K) as shown.

5. Push entire outfeed support assembly (J) Fig. 35, in

until it contacts splitter/guard assembly (L) as shown.

Then tighten all outfeed support mounting hardware.

Fig. 34

Fig. 31

Fig. 32

Fig. 33

Fig. 35

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 28 29

No comments

Delta ShopMaster A05581 Instruction Manual Page 17