Delta 37-360 Instruction Manual download pdf (Page 11)

SINGLE PHASE INSTALLATION

Fig. 12

Fig. 13 Fig. 14

1. Remove screw (A) Fig. 12, and terminal strip cover (B).

2. Remove plastic covering (C) Fig. 13, that snaps into

terminal strip.

3. Bring power line through access hole in bottom of

terminal strip box and connect the two power lines to

terminals (D) Fig. 14, and the green ground wire to ground

screw (E).

4. Replace plastic covering (C) Fig. 13, and terminal

strip cover removed in STEP 1.

IMPORTANT: The jointer cutterhead is a high inertia load which causes the motor to draw a high inrush

current during starting. The jointer must be connected to an electrical circuit protected by a properly sized

fuse or circuit breaker to handle this high inrush of current. We recommend either a 30 Amp time lag fuse, or

a 40 Amp motor start circuit breaker.

If your machine is supplied with single phase electricals, proceed as follows when connecting your machine to

an electrical power system:

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 23 24

No comments

Delta 37-360 Instruction Manual Page 11