--- 13 ---
1. Remove the two Tapping Screws (W/Washers) D5 x 20 [95] at the
right and the two Machine Screws M4 x 20 [100]. Remove the
Handle (Right) [99] from the Handle (Left) [97] with the Switch [91]
mounted.
2. Remove the two Truss Hd. Tapping Screws D4 x 12 [90] which fix
the Switch [91] to the Handle (Right) [99], and remove the Switch
[91].
3. Disconnect the internal wires of the Cord [83] and the Stator [129]
(See Fig. 16) from the Switch [91].
4. Remove the two Tapping Screws (W/Washers) D5 x 20 [95] at the
left to remove the Handle (Left) [97].
5. Remove the Chuck Nut M16 [30] by turning it with a 24 mm
wrench. Pull out the Special Bolt [79] by tapping it with a plastic
hammer. Separate the Motor Ass'y [78] from the Angle Regulator
[32].
Item
No.
Disassembly
spots
Disassembly procedure Necessary tools
2 Switch
Motor ass'y
29
30
31
32
33
6
7
37
41
34
35
36
38
78
76
77
84
85
79
86
87
88
89
82
101
80
83
81
Fig. 13
Phillips
Screwdriver
24 mm wrench
93
92
91
90
94
95
96
97
98
99
100
Plastic hammer
D5 metal bar
Comments to this Manuals