Delta 36-444 Instruction Manual download pdf (Page 12)

Fig. 21

WARNING: IMMEDIATELY AFTER ASSEMBLING

THE BELT, RAISE THE SAW BLADE TO ITS MAXIMUM

HEIGHT AND TILT THE SAW BLADE TO 45 DEGREES.

CHECK TO SEE IF THE MOTOR END BELL (J) FIG. 21,

IS BELOW THE TOP OF THE TABLE SURFACE (K). IF

THE MOTOR END BELL (J) IS ABOVE THE TOP OF

THE TABLE SURFACE, THE MOTOR MUST BE MOVED

TO THE LEFT UNTIL YOU ARE CERTAIN THE END

BELL (J) OF THE MOTOR IS BELOW THE TOP OF

THE TABLE SURFACE. THEN RE-ALIGN THE MOTOR

PULLEY TO THE ARBOR PULLEY.

Fig. 22

8. Assemble the outer cover (E) Fig. 22, of the belt and

pulley guard assembly, which was removed in STEP 3,

and fasten with external tooth lockwasher and wing nut

(D). IMPORTANT: Make certain the outer cover does not

interfere with the drive belt and the motor pulley.

Fig. 23

CONNECTING MOTOR CORD

TO SWITCH ASSEMBLY

WARNING: DISCONNECT MACHINE FROM

POWER SOURCE.

1. Insert the pronged motor plug (A) Fig. 23, into the

female receptacle (B) of switch-to-motor cord (C).

2. The motor cord connected to the switch assembly

is shown at (A) Fig. 24.

Fig. 24

OVERLOAD PROTECTION

The motor for use with your saw is equipped with a reset

overload relay button (B) Fig. 24. If the motor shuts off or

fails to start due to overloading (cutting stock too fast,

using a dull blade, using the saw beyond its capacity,

etc.), or low voltage, move the switch to the “OFF”

position, let the motor cool three to five

minutes and push the reset button (B), which will reset

the overload device.The motor can then be turned on

again in the usual manner.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 31 32

No comments

Delta 36-444 Instruction Manual Page 12