Delta 31-340 Instruction Manual download pdf (Page 9)

Fig. 13

Fig. 14

Fig. 15

Fig. 16

ASSEMBLING SANDING

DISC TABLE

1. DISCONNECT MACHINE FROM POWER SOURCE.

2. Two clamp handles are supplied with your machine,

one for the belt sander table and one for the disc sander

table. Disassemble both handles by unscrewing and re-

moving screw (A), spring (B), and handle (C) from locking

stud (D), as shown in Fig. 13.

4. Using locking stud (D) Fig. 13, from handle assembly,

and 10mm flat washer (J) Fig. 15, thread locking stud (H)

Fig. 15, into threaded hole in base casting to hold table

assembly (E) in place, as shown.

5. Assemble handle (C) Fig. 15, to locking stud (H) and

fasten with screw (A) and spring (B).

6. Fig. 16, illustrates the locking handle (C) assembled.

NOTE: The locking handle (C) is spring-loaded and can

be repositioned by pulling out the handle and

repositioning it on the serrated stud located underneath

the handle.

3. Position the disc table (E) Fig. 14, on the disc base

casting, making sure the key (F) on the table bracket is

engaged with the keyway (G) on the base casting.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 17 18

No comments

Delta 31-340 Instruction Manual Page 9