Delta (Model 31-300) Instruction Manual download pdf (Page 17)

REPLACING SANDING DISC

See “ATTACHING THE SANDING DISC” section in this manual.

Disconnect the machine from the power source.

SURFACING OR EDGE SANDING WITH SANDING BELT

When surfacing sanding (Fig. 41) or edge sanding (Fig. 42), place the sanding arm in the horizontal position. Use the

table (A) to keep the workpiece in place. Hold the workpiece firmly and keep your fingers away from the sanding belt.

Place the end of the workpiece against the table. Move the the workpiece evenly across the sanding belt. Apply only

enough pressure to allow the sanding belt to remove material. Use extra caution when sanding very thin pieces.

SANDING INSIDE CURVES

You can sand inside curves on the top sanding drum

(Fig. 43) if you loosen the knobs (A) Fig. 43 inset and

remove the guard

MACHINE USE

Fig.41 Fig.42

Position the edge of the table (A) Fig. 41 a maximum of 1/16" away from the sanding belt (B) to

avoid trapping the workpiece or your fingers between the table and the sanding belt.

Replace the sanding drum guard after the

sanding operation is completed.

SANDING OUTSIDE CURVES

Always sand on the left SIDE

(downward ROTATION side) of the sanding disc (Fig.

44). Sanding on the right SIDE (upward ROTATION

side) of the sanding disc could cause the workpiece

to fly up, which could be hazardous.

Position the edge of the table (A) Fig.

44 a maximum of 1/16" away from the sanding disc

(B) to avoid trapping the workpiece or your fingers

between the table and the sanding disc.

Fig.43

Fig.44

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 59 60

No comments

Delta (Model 31-300) Instruction Manual Page 17