Delta 11-950 Instruction Manual download pdf (Page 8)

MOTOR SPECIFICATIONS

Your drill press is wired for 110-120 volt, 60 HZ alternating current. Before connecting the machine to the power source,

make sure the switch is in the “OFF” position. The motor provides a no-load speed of 1725 RPM.

Fig. 13

GROUNDED OUTLET BOX

GROUNDING MEANS

ADAPTER

Fig. 12

GROUNDED OUTLET BOX

CURRENT

CARRYING

PRONGS

GROUNDING BLADE IS

LONGEST OF THE 3 BLADES

This tool is intended for use on a normal 120-volt circuit

and has a grounded plug that looks like the plug

illustrated in Fig. 12.

If a properly grounded outlet is not available, a temporary

adapter, shown in Fig. 13, may be used for connecting

the 3-prong grounding type plug to a 2-prong receptacle.

The temporary adapter should be used only until a

properly grounded outlet can be installed by a qualified

electrician. The green colored rigid ear, lug, or the like

extending from the adapter must be connected to a

permanent ground such as a properly grounded outlet

box. Whenever the adapter is used, it must be held in

place with a metal screw.

NOTE: In Canada, the use of a temporary adapter is

not permitted by the Canadian Electric Code.

CAUTION: IN ALL CASES, MAKE CERTAIN THE RE-

CEPTACLE IN QUESTION IS PROPERLY GROUNDED.

IF YOU ARE NOT SURE HAVE A CERTIFIED ELEC-

TRICIAN CHECK THE RECEPTACLE.

GROUNDING INSTRUCTIONS

WARNING: THIS TOOL MUST BE GROUNDED WHILE IN USE TO PROTECT THE OPERATOR FROM

ELECTRIC SHOCK.

In the event of a malfunction or breakdown, grounding provides a path of least resistance for electric current to reduce

the risk of electric shock. This tool is equipped with an electric cord having an equipment-grounding conductor and a

grounding plug. The plug must be plugged into a matching outlet that is properly installed and grounded in accordance

with all local codes and ordinances.

Do not modify the plug provided - if it will not fit the outlet, have the proper outlet installed by a qualified electrician.

Improper connection of the equipment-grounding conductor can result in risk of electric shock. The conductor with

insulation having an outer surface that is green with or without yellow stripes is the equipment-grounding conductor. If

repair or replacement of the electric cord or plug is necessary, do not connect the equipment-grounding conductor to

a live terminal.

Check with a qualified electrician or service personnel if the grounding instructions are not completely understood, or

if in doubt as to whether the tool is properly grounded. Use only 3-wire extension cords that have 3-prong grounding

type plugs and 3-hole receptacles that accept the tool’s plug, as shown in Fig. 12.

Repair or replace damaged or worn cord immediately.

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Comments to this Manuals

No comments

Delta 11-950 Instruction Manual Page 8

Comments to this Manuals

Related products and manuals for Power tools Delta 11-950