Delta 11-985 Instruction Manual download pdf (Page 12)

Fig. 27

Fig. 28

TABLE ADJUSTMENTS

1. The table can be raised or lowered on the drill press

column by loosening the table clamp handle (A) Fig. 27,

and turning the table raising and lowering handle (B) Fig.

28. After the table is at the desired height, tighten handle

(A) Fig. 27. NOTE: Final positioning of the drill press

table should always be from the bottom to the up

position.

2. The table can be rotated 360 degrees on the column

by loosening clamp handle (A) Fig. 27, rotate table to

desired position and tighten clamp handle (A).

3. The table can be tilted right or left by pulling out and

removing table alignment pin (C) Fig. 29, and loosening

table locking bolt (D). NOTE: If pin (C) is difficult to

remove, turn nut (E) clockwise to pull pin out of casting.

Tilt table to the desired angle and tighten bolt (D).

4. When returning table to the level position, loosen

set screw (C) Fig. 30, and loosen locking bolt (D).

Position the table to the 0 degree mark on the tilt scale

and then tighten the set screw (C) and locking bolt (D)

Fig. 29.

5. A tilt scale (E) Fig. 31, is provided on the table

bracket casting to indicate the degree of tilt. A witness

line (F) is also provided on the table to line up with scale

(E).

Fig. 29

Fig. 30 Fig. 31

1 2 ... 7 8 9 10 11 12 13 14 15 16

No comments

Delta 11-985 Instruction Manual Page 12