Delta 11-985 Instruction Manual download pdf (Page 5)

CLEANING

Remove the protective coating from the machined surfaces of the drill press and all loose items. This coating may be

removed with a soft cloth moistened with kerosene. DO NOT use acetone, gasoline, or lacquer thinner for this purpose.

ASSEMBLING THE DRILL PRESS

Fig. 3

1. Assemble the column (A) Fig. 3, to the base (B) using

the four screws, three of which are shown at(C). Loosen

set screw (D) and remove ring (E) and raising rack (F).

Fig. 4

Fig. 5

2. Make certain worm gear (G) Figs. 4 and 5, is in place

in table bracket (H) as shown.

Fig. 6

3. Insert raising rack (F) Fig. 6, which was removed in

STEP 1, into groove in table bracket making sure teeth

of worm gear (G) located inside table bracket are

engaged with teeth of raising rack (F).

1 2 3 4 5 6 7 8 9 10 ... 15 16

No comments

Delta 11-985 Instruction Manual Page 5