Delta 14-070 User Manual download pdf (Page 4)

THE FOLLOWING INSTRUCTIONS ARE FOR THE DELTA 17-900 16-1/2" DRILL PRESS.

Disconnect the machine from the power source.

NOTE: This unit requires NO bushings for attaching the chisel holder to the quill.

1. Insert and lock the smaller diameter end of the alignment pin

(A) Fig. 12 into the spindle.

2. Slide the chisel holder (B) Fig. 12 over the alignment pin and

over the stop collar (C) of the drill press.

NOTE: Face the slot (D) in the chisel holder (B) toward the front

of the drill press.

3. Tighten the thumb screw (F) Fig. 12 on the alignment pin

first, then tighten the locking lever (E).

NOTE: The locking lever is spring-loaded. Change it by pulling

out and repositioning the hub of the lever on the nut located

directly under the hub.

4. Loosen the thumb screw (E) and remove the alignment pin

(A) from the spindle.

ATTACHING THE FENCE TO THE TABLE

THE FOLLOWING INSTRUCTIONS ARE FOR THE 10", 12", 14", AND 32" RADIAL DRILL PRESSES AND THE

MODEL 17-900, LISTED IN THE INTRODUCTION.

1. Attach the fence (A) Fig. 13 to the drill press table with two

locking levers (C and Y), flat washers (D) and T-nuts (E).

IMPORTANT: The T-nuts are positioned under the drill press

table.

NOTE: For ease of assembly, you can remove the locking levers

springs (B). Attach the studs (F) first, then re-attach the lever

(Y) to the stud (F). You can reposition the locking levers (C)

and (Y) by lifting the upward and rotating them on the stud in

either direction.

THE FOLLOWING INSTRUCTIONS ARE FOR THE 15" UTILITY AND MODEL 17-925 16-1/2" VARIABLE SPEED

DRILL PRESSES.

1. Attach the fence (A) Fig. 14 to the drill press table with two

locking levers (C and Y), flat washers (D) and T-nuts (E), one

of which is shown in the assembly (C).

NOTE: You can rotate the T-nuts (one of which is shown insert-

ed in the t-slot of the drill press table) 90 degrees if neces-

sary to fit properly inside the T-slot in the table.

NOTE: For ease of assembly, you can remove the locking levers

(C and Y) from the stud by removing the screws and springs

(B). Re-attach the studs (F) first, then the levers (C and Y) to

the studs. You can reposition the locking levers (C) and (Y) by

lifting the upward and rotating them on the stud in either

direction.

Fig. 14

Fig. 13

Fig. 12

Disconnect the machine from the power source.

1 2 3 4 5 6 7 8

Comments to this Manuals

No comments

Delta 14-070 User Manual Page 4

Comments to this Manuals

Related products and manuals for Power tools Delta 14-070