Delta 23-710 Instruction Manual download pdf (Page 14)

Fig. 39

Fig. 35

Fig. 36

Fig. 37

Fig. 38

3. Remove the tool rest and mounting post (E) Fig. 35,

from the wet wheel side of the machine and insert

post of tool rest assembly into hole (F). Tighten screw

(G) into groove of mounting post. All controls and ad-

justments for the tool rest are explained in the sec-

tion “ASSEMBLING AND AD JUST ING TOOL AND

CHISEL HOLDER.”

4. Figure 36, illustrates a rough grinding operation on a

plane iron (H) using the dry wheel.

ASSEMBLING OPTIONAL

ACCESSORY 23-715 SLIDING TOOL

REST TO WET WHEEL

The 23-715 Sliding Tool Rest is available as an acces-

sory for your sharpening center and is especially suited

for sharpening jointer and planer knives. To assemble the

23-715 Sliding Tool Rest, proceed as follows:

1. Loosen screw (A) Fig. 37, and remove tool and chisel

holder assembly (B) as shown.

2. Assemble slid ing table tool rest base (E) Fig. 38,

to mounting post (A) and tighten screw (F) against

groove (G) in mounting post.

3. Place flat washer, spring and another flat washer

onto the tilting screw knob included with the 23-715.

Thread tilting screw and spring assembly (H) Fig. 39,

into hole in left post.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 63 64

No comments

Delta 23-710 Instruction Manual Page 14