Delta 28-150 Instruction Manual download pdf (Page 10)

OPERATING CONTROLS AND ADJUSTMENTS

Fig. 20

Fig. 21

Fig. 22

Fig. 23

STARTING AND

STOPPING SAW

The switch (A) Fig. 20, is located on the front side of the

band saw. To turn the saw “ON” move the switch (A) to

the up position. To turn the saw “OFF” move the switch

(A) to the down position.

LOCKING SWITCH IN

THE “OFF” POSITION

When the tool is not in use, the switch be locked in the

“OFF” position. This can be done by grasping the switch

toggle (B) Fig. 21, and pulling it out of the switch, as

shown. With the switch toggle (B) removed, the switch will

not operate. However, should the switch toggle be

removed while the machine is running, the switch can be

turned “OFF” once, but cannot be restarted without

inserting the switch toggle (B).

OPENING AND CLOSING

HINGED DOOR

For the purpose of making adjustments such as changing

the blade, tracking the blade, blade guide adjustments,

etc., the hinged door (B) Figs. 22 and 23, must be opened

as follows:

1. CAUTION: NEVER OPEN THE HINGED DOOR

WHEN THE MACHINE IS RUNNING.

2. Press in the two locking latches (A) Fig. 22, and swing

door (B) open.

3. Fig. 23, illustrates door (B) in open position.

4. To close and fasten door (B) Figs. 22 and 23, press on

door directly over latches (A) Fig. 22, until latches snap

into the locking position.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

No comments

Delta 28-150 Instruction Manual Page 10