Delta 28-150 Instruction Manual download pdf (Page 5)

ASSEMBLY INSTRUCTIONS

Fig. 4

ASSEMBLING TABLE

TO MACHINE

1. Locate table locking lever (shown disassembled)

Fig. 4, flat washer (B) and 4mm wrench (C).

2. Using 4mm wrench (C) Fig. 4, supplied, remove

screw (D) and spring (E) from handle (A) and remove

handle from nut (G). Do not lose spring (E).

3. Place table (H) Fig. 5, onto the band saw frame so

that stud (J) Fig. 6, and keepers (K) protrude through the

slot of trunnion (L) Fig. 7.

4. While pressing in on stud (M) Fig. 8 with a pencil,

place flat washer (B) Fig. 7, onto stud and thread nut (G)

onto stud as shown in Fig. 4 and Fig. 7.

Fig. 5

WARNING: FOR YOUR OWN SAFETY, DO NOT

CONNECT THE BAND SAW TO THE POWER

SOURCE UNTIL THE MACHINE IS COMPLETELY

ASSEMBLED AND YOU HAVE READ AND UNDER-

STOOD THE ENTIRE OWNER’S MANUAL.

Fig. 6

Fig. 8Fig. 7

B G

1 2 3 4 5 6 7 8 9 10 ... 23 24

No comments

Delta 28-150 Instruction Manual Page 5