Delta 36-040 Instruction Manual download pdf (Page 5)

3. Slide slotted end (E) Fig. 7, of lower guard mounting

bracket under screw head (D). Make sure screw and

spacer (K) is engaged with slot (L) in guard lifting lever

and rotate lower guard mounting bracket (F) until hole (G)

in bracket lines up with threaded hole (H) in upper guard.

4. Replace screw (C) Fig. 8, that was removed in

STEP 2. Tighten screw (D) and screw (C).

ASSEMBLING DUST BAG

Assemble dust bag assembly (A) Fig. 9, to dust spout (B)

on rear of upper guard assembly, as shown.

FASTENING COMPOUND MITER

SAW TO SUPPORTING SURFACE

CAUTION: Before operating your compound miter saw,

make sure it is firmly mounted to a sturdy work bench or

other supporting surface. Four holes are provided, two

of which are shown at (A) Fig. 10, for fastening the saw

to a supporting surface.

When frequently moving the saw from place to place,

we suggest that the saw be mounted to a 1/2" or 3/4"

piece of plywood. The saw can then be easily moved

and the plywood clamped to the supporting surface

using “C” clamps.

Fig. 10

Fig. 9

Fig. 8

Fig. 7

1 2 3 4 5 6 7 8 9 10 ... 16 17

No comments

Delta 36-040 Instruction Manual Page 5