Delta 36-040 Instruction Manual download pdf (Page 6)

CONNECTING SAW TO POWER SOURCE

POWER CONNECTIONS

A separate electrical circuit should be used for your tools. This circuit should not be less than #12 wire and should be

protected with a 20 Amp time lag fuse. Before connecting the motor to the power line, make sure the switch is in the

“OFF” position and be sure that the electric current is of the same characteristics as indicated on the tool. All line con-

nections should make good contact. Running on low voltage will damage the motor.

MOTOR SPECIFICATIONS

Your miter saw is wired for 110-120 volt, 60 HZ alternating current. Before connecting the miter saw to the power

source, make sure the switch is in the “OFF” position. The motor provides a no-load speed of 5200 RPM.

DOUBLE-INSULATED TOOLS

REPLACEMENT PARTS

When servicing, use only identical replacement parts.

POLARIZED PLUGS

To reduce the risk of electric shock, this equipment has a polarized plug one blade is wider than the other). This plug

will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit,

contact a qualified electrician to install the proper outlet. Do not change the plug in any way.

1 2 3 4 5 6 7 8 9 10 11 ... 16 17

No comments

Delta 36-040 Instruction Manual Page 6