Delta 36-714B Instruction Manual download pdf (Page 11)

1. Insert the female end of the switch cord through the hole (F) Fig. 13 in the corner of the saw. Open the motor cover and

route the switch cord (F) Fig. 14 behind the cord guard (G). Plug the switch cord into the motor cord (H) Fig. 14.

2. Remove all slack and rest the cord on the dust chute.

Do not allow the cord to come in contact with the blade, belt, or pulleys.

Fig. 13

Fig. 14

HOW TO ATTACH THE BLADE GUARD AND SPLITTER ASSEMBLY

Disconnect the machine from the power source!

If the saw blade is attached to the saw, remove it using the supplied wrenches.

HOW TO ROUTE THE CORD

1. Fasten the rear splitter mounting bracket (A) Fig. 15 to the rear trunnion. Align the two holes (B) in the rear splitter

mounting bracket with the two holes in the trunnion. Place a 1/4" lock washer and a 1/4" flat washer on a 1/4-20 x

3/4" hex-head bolt. Position the bolt through the hole in the rear splitter mounting bracket. Thread the bolt into the rear

trunnion. Repeat this process for the remaining hole. Loosely tighten the hardware for further adjustment.

2. Raise the saw arbor to its highest position.

3. Remove the screw, lock washer and large washer (C) Fig. 16 (and pictured in inset) from the inside splitter mounting

bracket.

Fig. 15

Fig. 16

4. Use a straight edge to check the alignment of the top and bottom of the inside splitter bracket (D) Fig. 17 with the inner

arbor flange (E).

5. To align, loosen the two screws, (F) Fig. 18, align the bracket (D) with the arbor flange and tighten the screws (F).

6. Loosely attach the large washer, lock washer and screw (inset) Figs. 17 and 18 (removed earlier) to the inside splitter

bracket.

Fig. 17

Fig. 18

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 75 76

No comments

Delta 36-714B Instruction Manual Page 11