Delta 36-714B Instruction Manual download pdf (Page 14)

Install the fence holders (A) Fig. 30 using four (4) 1/4"-20 x

3/8" self-tapping screws.

Install the wrench hook (B) using two (2) M4 x 8mm self-

tapping screws.

Attach the dust port (D) Fig. 31 using four 1/4-20 x 3/8"

self-tapping screws.

Make sure that the table insert (A) is always

level with the table.

Place a straight edge (B) Fig. 29 across the table at both

ends of the table insert (A).

To adjust, loosen the screw (D) Fig. 29 and turn the adjusting

screws (C) Fig. 29 with the supplied hex wrench.

HOW TO ADJUST THE TABLE INSERT

Disconnect the machine from the power source!

Fig. 29

Fig. 30

Fig. 31

HOW TO INSTALL THE TOOL HOLDERS

Disconnect the machine from the power source!

HOW TO INSTALL THE DUST PORT

Disconnect the machine from the power source!

HOW TO ASSEMBLE AND OPERATE THE MITER GAUGE

Disconnect the machine from the power source!

Refer to the instruction sheet that came with your 36-946 miter gauge for assembly and operation instructions.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 75 76

No comments

Delta 36-714B Instruction Manual Page 14