Delta 36-850 Instruction Manual download pdf (Page 11)

Position the feeder assembly (A) Fig. 10 on a table saw

so that the saw blade is between the middle roller (B)

and the outfeed roller (C) and slightly angled to the

direction of the feed. For example, the outfeed roller (C)

should be approximately 1/4" closer to the fence (D)

than the infeed roller (E), Fig. 10. This position will keep

the workpiece against the fence.

Position the feeder assembly (A) Fig. 12 so that the

shaper cutter is between the middle roller (B) and the

outfeed roller (C). Position the outfeed roller (C) approx-

imately 1/4" closer to the outfeed fence (E) than the

infeed roller (D).

USING THE STOCK FEEDER ON A TABLE SAW

USING THE STOCK FEEDER ON A JOINTER

USING THE STOCK FEEDER ON A SHAPER

Position the feeder assembly (G) on a jointer so that all

the rollers (A, B, and C) are over the outfeed table (D) of

the jointer (Fig. 11). The first roller (C) should be approx-

imately 1/4" from the leading edge (E) of the outfeed

table and the third roller (A) should be approximately

1/4" closer to the fence (F) than the first roller (C). The

downward pressure of the rollers on the stock should be

as light as possible.

Fig. 10

Fig. 11

Fig. 12

A E

1 2 ... 6 7 8 9 10 11 12 13 14 15 16

No comments

Delta 36-850 Instruction Manual Page 11