Delta 36-979 Instruction Manual download pdf (Page 11)

LEVELING EXTENSION TABLES

The extension tables (A) and (G) Fig. 14 must be level

with the planer table. To check the extension tables and

adjust if necessary:

1. Place a straight edge (B) Fig. 14 on the planer table

(E) with one end extending out over the infeed table

(A). Check to see if the infeed table is level with the

planer table on both ends of the planer table.

2. If an adjustment is necessary, loosen the locknut (C)

Fig. 14, and adjust the stop screw (D) on each side

of the infeed table (A) until the extension table is

level with the planer table (E). Tighten the locknut

(C). Recheck and make certain that the inside edge

of table extension is level with the planer table.

If necessary, loosen the two screws (F), adjust

the extension table and retighten the two screws

(F). Adjust the opposite side of the table in the same

manner. Make certain that the extension table is

solidly supported when downward pressure on the

table is applied.

3. Check and adjust the outfeed table (G) in the same

manner.

KNIFE TRANSFER TOOL STORAGE

The knife transfer tool (A) Fig. 15, supplied with your

planer, can easily be stored underneath the outfeed table

extension (B) when not being used. A Velcro strip (C) is

provided on the tool and underneath the table for this

purpose.

WRENCH STORAGE

The wrench (A) Fig. 16, can be stored in hole (B) located

on the right rear side of the machine as shown.

Fig. 15

Fig. 16

Fig. 14

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 17

No comments

Delta 36-979 Instruction Manual Page 11